1. LIST OF ALARMS
1.1 Operation Alarm
I - 6
Error No. Details Remedy
0126
Program restart machine lock
Machine lock was applied on the return
axis while manually returning to the
restart position.
• Release the machine lock before
resuming operations.
0150
Chopping override zero • Check the chopping override (R135).
• Check the rapid traverse override (R134).
0151
Command axis chopping axis
A chopping axis movement command
was issued from the program during the
chopping mode. (This alarm will not
occur when the movement amount is
commanded as 0.)
(All axes interlock state will be applied.)
• Reset, or turn OFF the chopping signal.
When the chopping signal is turned OFF,
the axis will return to the reference
position, and then the program movement
command will be executed.
0153
Bottom dead center position zero
The bottom dead center position is set to
the same position as the upper dead
center position.
• Correctly set the bottom dead center
position.
0154
Chopping axis handle selection axis
Chopping was started when the
chopping axis was selected as the
handle axis.
• Select an axis other than the chopping
axis as the handle axis, or start chopping
after changing the mode to another
mode.
0160
Axis with no maximum speed set for the
outside of the soft limit range
Returned from the outside of the soft
limit range for the axis with no maximum
speed set for the outside of the soft limit
range.
• Set the maximum speed for the outside of
the soft limit range. (Parameter "#2021
out_f")
• Change the soft limit range.
(Parameter "#2013 OT–" "#2014 OT+")
1005
An attempt was made to execute G114.*
during execution of G114.*.
G51.2 was commanded when the G51.2
spindle-spindle polygon machining mode
was already entered with a separate
system.
• Issue G113 to cancel G114.*.
• Issue the spindle synchronous cancel
signal (Y2E8: SPSYC) to cancel G114.*.
• Cancel with G50.2.
• Cancel with the spindle-spindle polygon
cancel signal (Y359).
1007
The spindle is being used in synchronized
tapping.
• Cancel synchronized tapping.
1026
Spindle C axis and other position control
were commanded simultaneously.
C axis mode command was issued for
polygon machining spindle.
C axis mode command was issued for
synchronized tapping spindle.
Polygon command was issued for
synchronized tapping spindle.
Spindle is being used as spindle/C axis.
• Cancel the C axis command.
• Cancel the polygon machining command.
• Cancel the C axis with servo OFF.
England 
Deutschland 
France 
Italia 
Polska 
United Kingdom 
Россия 
Nederland 
España 
Magyarország 
Sverige 
România 
Portugal 
Colombia 
Suomi 
New Zealand 
Česká republika 
Türkiye 
Danmark 
日本